>я давно ушел с freenibs - утечки памяти под большой нагрузкой, низкая
>маштабируемость, ну и кривость движка - запихивать щиталку в радиус это
>дыбилизм, развитие = 0. У каждого приложения должны быть свои задачи,
>а делать из велосипеда тактор, не наш метод. Поробуйте лучше http://abills.net.ua/wiki/doku.php
>Можно конечно долго посмеяться но у Abills та же самая ошибка - не воспринимает авторризацию по VPN. Вот вывод радиуса при авторизации:
rad_recv: Access-Request packet from host 127.0.0.1:32771, id=25, length=84
Service-Type = Framed-User
Framed-Protocol = PPP
User-Name = "qwerty"
User-Password = "qwerty"
Calling-Station-Id = "192.168.2.13"
NAS-IP-Address = 127.0.0.1
NAS-Port = 0
Processing the authorize section of radiusd.conf
modcall: entering group authorize for request 0
radius_xlat: '/usr/abills/libexec/rauth.pl pre_auth'
Exec-Program: /usr/abills/libexec/rauth.pl pre_auth
Exec-Program output: Auth-Type := Accept
Exec-Program-Wait: value-pairs: Auth-Type := Accept
Exec-Program: returned: 0
modcall[authorize]: module "pre_auth" returns ok for request 0
modcall[authorize]: module "preprocess" returns ok for request 0
rlm_realm: No '@' in User-Name = "qwerty", looking up realm NULL
rlm_realm: No such realm "NULL"
modcall[authorize]: module "suffix" returns noop for request 0
users: Matched entry DEFAULT at line 155
modcall[authorize]: module "files" returns ok for request 0
modcall: leaving group authorize (returns ok) for request 0
rad_check_password: Found Auth-Type Accept
rad_check_password: Auth-Type = Accept, accepting the user
radius_xlat: '/usr/abills/libexec/rauth.pl'
Exec-Program: /usr/abills/libexec/rauth.pl
Exec-Program output: Reply-Message = "Unknow server '127.0.0.1'"
Exec-Program-Wait: value-pairs: Reply-Message = "Unknow server '127.0.0.1'"
Exec-Program: returned: 1
Found Post-Auth-Type
Processing the post-auth section of radiusd.conf
modcall: entering group REJECT for request 0
radius_xlat: '/usr/abills/libexec/rauth.pl post_auth'
Exec-Program: /usr/abills/libexec/rauth.pl post_auth
Exec-Program output:
Exec-Program: returned: 0
modcall[post-auth]: module "post_auth" returns ok for request 0
modcall: leaving group REJECT (returns ok) for request 0