>Все сидит в интераптах, в ip input пусто - похоже проблема
>в linecard (или может режим неправильный или еще что)Теоретически это понятно - осталось только найти, где именно ошибка :)
>sh ver
cat-6509#show version
Cisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXH3, RELEASE SOFTWARE (fc1)[skip]
ROM: System Bootstrap, Version 12.2(17r)S4, RELEASE SOFTWARE (fc1)
[skip]
cisco WS-C6509 (R7000) processor (revision 2.0) with 983008K/65536K bytes of memory.
Processor board ID SCA040300G2
SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache
Last reset from s/w reset
238 Virtual Ethernet interfaces
96 FastEthernet interfaces
50 Gigabit Ethernet interfaces
1917K bytes of non-volatile configuration memory.
8192K bytes of packet buffer memory.
65536K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x2102
>sh modules
cat-6509#show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
2 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX SAL1052C0HK
5 2 Supervisor Engine 720 (Active) WS-SUP720-3BXL SAL10446GRC
8 48 SFM-capable 48-port 10/100 Mbps RJ45 WS-X6548-RJ-45 SAL0701B5KK
9 48 48 port 10/100 mb RJ45 WS-X6348-RJ-45 SAL0547ED6SMod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
2 001a.6d39.8e48 to 001a.6d39.8e77 11.1 7.2(1) 8.7(0.22)BUB Ok
5 0016.9df6.afe0 to 0016.9df6.afe3 5.2 8.4(2) 12.2(33)SXH3 Ok
8 0009.11f2.9b98 to 0009.11f2.9bc7 5.1 6.3(1) 8.7(0.22)BUB Ok
9 0005.7408.ddb0 to 0005.7408.dddf 5.0 5.4(2) 8.7(0.22)BUB Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
5 Policy Feature Card 3 WS-F6K-PFC3BXL SAL10436AE6 1.8 Ok
5 MSFC3 Daughterboard WS-SUP720 SAL10446EYV 2.5 Ok
Mod Online Diag Status
---- -------------------
2 Pass
5 Pass
8 Pass
9 Pass
>sh runn
Я ж писал - под 100 Кб. Говори, что нужно показать - я покажу. Смысла не вижу весь конфиг постить...
>sh cef summ - или как там его :)
cat-6509#show ip cef summary
IPv4 CEF is enabled for distributed and running
VRF Default:
1513 prefixes (1513/0 fwd/non-fwd)
Default network 0.0.0.0/0
Table id 0
Database epoch: 5 (1513 entries at this epoch)
