Доброго всем дня . Есть проблема , стоит Cisco 2960 Catalyst на интерфейсе проявились дропы на некоторых портах , раньше делал QOS на ней - далее все это убрал , но дропы так и остались . Подскажите в чем может быть проблема ?FastEthernet0/3 is up, line protocol is up (connected) Hardware is Fast Ethernet, address is 001e... MTU 1508 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Half-duplex, 10Mb/s, media type is 10/100BaseTX input flow-control is off, output flow-control is unsupported ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output 00:00:01, output hang never Last clearing of "show interface" counters 1d00h Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 79 Queueing strategy: fifo Output queue: 0/0 (size/max) 30 second input rate 0 bits/sec, 0 packets/sec 30 second output rate 0 bits/sec, 0 packets/sec 213969 packets input, 40581220 bytes, 0 no buffer Received 173 broadcasts (0 multicasts) 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 0 multicast, 0 pause input 0 input packets with dribble condition detected 328358 packets output, 215177591 bytes, 0 underruns 0 output errors, 44700 collisions, 0 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 PAUSE output 0 output buffer failures, 0 output buffers swapped out
|