Доброе время суток, Уважаемые!
Имеется маршрутизатор Cisco 1841
Включаю вижу следующее:System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c1841 platform with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
Readonly ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
loadprog: error - not an executable ELF file
boot: cannot load "flash:"
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c1841 platform with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
Readonly ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
loadprog: error - not an executable ELF file
boot: cannot load "flash:"
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c1841 platform with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
Readonly ROMMON initialized
rommon 1 >
rommon 1 >
rommon 1 >
Пробовал "confreg 0x2102 - не помогает(((
Пробовал "reset" тоже самое(
Пробовал сделать следующее:
rommon 1 > IP_ADDRESS=10.0.0.2
rommon 2 > IP_SUBNET_MASK=255.255.255.252
rommon 3 > DEFAULT_GATEWAY=10.0.0.1
rommon 4 > TFTP_SERVER=10.0.0.1
rommon 5 > TFTP_FILE=c1841-advsecurityk9-mz.124-11.T2.bin
rommon 6 > tftpdnld
Пишет:
IP_ADDRESS: 10.0.0.2
IP_SUBNET_MASK: 255.255.255.252
DEFAULT_GATEWAY: 10.0.0.1
TFTP_SERVER: 10.0.0.1
TFTP_FILE: c1841-advsecurityk9-mz.124-11.T2.bin
TFTP_MACADDR: 00:1b:d4:f1:2b:e4
TFTP_VERBOSE: Progress
TFTP_RETRY_COUNT: 18
TFTP_TIMEOUT: 7200
TFTP_CHECKSUM: Yes
FE_PORT: 0
FE_SPEED_MODE: Auto Detect
Invoke this command for disaster recovery only.
WARNING: all existing data in all partitions on flash: will be lost!
Do you wish to continue? y/n: [n]: y
.
Receiving c1841-advsecurityk9-mz.124-11.T2.bin from 10.94.255.1
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
File reception completed.
Validating checksum.
Copying file c1841-advsecurityk9-mz.124-11.T2.bin to flash:.
program load complete, entry point: 0x8000f000, size: 0xcb80
Format: Drive communication & 1st Sector Write OK...
Writing Monlib sectors.
.....................................................................................................
..
Monlib write complete
Format: All system sectors written. OK...
Format: Operation completed successfully.
Format of flash: complete
program load complete, entry point: 0x8000f000, size: 0xcb80
rommon 7 >
Пишет вроде все успешно прошло, делаю "reset" пишет следующее:
loadprog: bad file magic number: 0x0
boot: cannot load "flash:"
и снова "rommon"
Вроде флешку видит, но почему то загрузится не может( помогите разобраться в чем может быть проблема.
Очень рассчитываю на вашу помощь, заранее искренне благодарен!
