>>Проблема вроде решена, установил из тестовой ветки, сетевуха нашлась, глюков пока не
>>обнаружено
>
>etch это тестовая -- или читать вы не пробывали Я не правильно выразился :) Имелось ввиду что установил Debian lenny. Ядро 2.6.26-1-686. Сетевая определилась как "Broadcom Corporation NetXtreme BCM5722 Gigabit Ethernet PCI Express". Но заметил в dmesg:
...
[ 0.268608] PCI: Cannot allocate resource region 7 of bridge 0000:00:01.0
[ 0.268608] PCI: Cannot allocate resource region 7 of bridge 0000:00:1c.0
...
[ 4.082449] scsi2 : ata_piix
[ 4.082449] scsi3 : ata_piix
[ 4.082449] ata3: SATA max UDMA/133 cmd 0x1c68 ctl 0x1c5c bmdma 0x1c30 irq 18
[ 4.082449] ata4: SATA max UDMA/133 cmd 0x1c60 ctl 0x1c58 bmdma 0x1c38 irq 18
[ 4.557531] ata3: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
[ 4.565687] ata3.00: ATAPI: HL-DT-STDVD-ROM GDRH20N, D8E4, max UDMA/100
[ 4.581682] ata3.00: configured for UDMA/100
[ 4.913457] ata4: SATA link down (SStatus 0 SControl 300)
[ 4.913447] scsi 2:0:0:0: CD-ROM HL-DT-ST DVD-ROM GDRH20N D8E4 PQ: 0 ANSI: 5
[ 5.068575] Uniform Multi-Platform E-IDE driver
[ 5.068580] ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
[ 5.087048] Driver 'sd' needs updating - please use bus_type methods
[ 5.087156] sd 0:0:0:0: [sda] 312581808 512-byte hardware sectors (160042 MB)
[ 5.087171] sd 0:0:0:0: [sda] Write Protect is off
[ 5.087174] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
[ 5.087198] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[ 5.087262] sd 0:0:0:0: [sda] 312581808 512-byte hardware sectors (160042 MB)
[ 5.087276] sd 0:0:0:0: [sda] Write Protect is off
[ 5.087279] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
[ 5.087304] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[ 5.087310] sda:<4>Driver 'sr' needs updating - please use bus_type methods
[ 5.107607] sda1 sda2 < sda5 >
[ 5.128830] sd 0:0:0:0: [sda] Attached SCSI disk
[ 5.134122] sr0: scsi3-mmc drive: 40x/40x cd/rw xa/form2 cdda tray
[ 5.134122] Uniform CD-ROM driver Revision: 3.20
[ 5.134122] sr 2:0:0:0: Attached scsi CD-ROM sr0
[ 5.142147] sd 0:0:0:0: Attached scsi generic sg0 type 0
[ 5.142147] sr 2:0:0:0: Attached scsi generic sg1 type 5
[ 5.299935] PM: Starting manual resume from disk
...
[ 7.823446] Error: Driver 'pcspkr' is already registered, aborting...
Это нормально?
|
