Исходное сообщение
"3845 + NM-1ce1t1-pri" Отправлено flashdumper, 23-Дек-08 18:42
Не могу настроить эту железку на соединение с E1 от прова. Итак настройки: card type e1 2 isdn switch-type primary-net5 controller E1 2/0 pri-group timeslots 1-30 interface Serial2/0:15 no ip address encapsulation hdlc isdn switch-type primary-net5 no cdp enable У меня вопрос, почему я не вижу voice-port s2/0:1 ? CCME(config)#voice-port ?   <3-50>  Voice interface slot # Cisco IOS Software, 3800 Software (C3845-SPSERVICESK9-M), Version 12.4(22)T, RELEASE SOFTWARE (fc1) Другой ИОС пробовал, ничего не изменилось! Чего еще не хватает!? Вот еще: CCME#sh controllers e1 2/0 br E1 2/0 is up.   Applique type is Channelized E1 - balanced   No alarms detected.   alarm-trigger is not set   Framing is CRC4, Line Code is HDB3, Clock Source is Line.   Module type is Channelized E1/T1 PRI   Version info Firmware: 0000001D, FPGA: C   Hardware revision is 0.0         , Software revision is 29   Protocol revision is 1   number of CLI resets is 0     receive remote alarm  :    0,     transmit remote alarm :    0,     receive AIS alarm     :    0,     transmit AIS alarm    :    0,     loss of frame         :    0,     loss of signal        :    0,     Loopback test         :    0,     transmit AIS in TS 16 :    0,     receive LOMF alarm    :    0,     transmit LOMF alarm   :    0,   MIB data updated every 10 seconds.   Data in current interval (832 seconds elapsed):      0 Line Code Violations, 0 Path Code Violations      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs   Total Data (last 2 15 minute intervals):      0 Line Code Violations, 0 Path Code Violations,      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 6 Unavail Secs CCME#sh int s2/0:15 Serial2/0:15 is up, line protocol is up (spoofing)   Hardware is DSX1   MTU 1500 bytes, BW 64 Kbit/sec, DLY 20000 usec,      reliability 255/255, txload 1/255, rxload 1/255   Encapsulation HDLC, loopback not set   Last input 00:00:05, output 00:00:05, output hang never   Last clearing of "show interface" counters never   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0   Queueing strategy: weighted fair   Output queue: 0/1000/64/0 (size/max total/threshold/drops)      Conversations  0/1/256 (active/max active/max total)      Reserved Conversations 0/0 (allocated/max allocated)      Available Bandwidth 48 kilobits/sec   5 minute input rate 0 bits/sec, 0 packets/sec   5 minute output rate 0 bits/sec, 0 packets/sec      475 packets input, 1905 bytes, 0 no buffer      Received 0 broadcasts, 0 runts, 0 giants, 0 throttles      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort      475 packets output, 1905 bytes, 0 underruns      0 output errors, 0 collisions, 1 interface resets      0 unknown protocol drops      0 output buffer failures, 0 output buffers swapped out      1 carrier transitions   Timeslot(s) Used:16, Transmitter delay is 0 flags CCME#sh ip int br Interface                  IP-Address      OK? Method Status                Protocol GigabitEthernet0/0         10.1.3.254      YES NVRAM  up                    up     GigabitEthernet0/1         unassigned      YES TFTP   administratively down down   In1/0                      192.168.1.5     YES TFTP   administratively down down   Serial2/0:0                unassigned      YES unset  down                  down   Serial2/0:1                unassigned      YES unset  down                  down   Serial2/0:2                unassigned      YES unset  down                  down   Serial2/0:3                unassigned      YES unset  down                  down   Serial2/0:4                unassigned      YES unset  down                  down   Serial2/0:5                unassigned      YES unset  down                  down   Serial2/0:6                unassigned      YES unset  down                  down   Serial2/0:7                unassigned      YES unset  down                  down   Serial2/0:8                unassigned      YES unset  down                  down   Serial2/0:9                unassigned      YES unset  down                  down   Serial2/0:10               unassigned      YES unset  down                  down   Serial2/0:11               unassigned      YES unset  down                  down   Serial2/0:12               unassigned      YES unset  down                  down   Serial2/0:13               unassigned      YES unset  down                  down   Serial2/0:14               unassigned      YES unset  down                  down   Serial2/0:15               unassigned      YES TFTP   up                    up     Serial2/0:16               unassigned      YES unset  down                  down   Serial2/0:17               unassigned      YES unset  down                  down   Serial2/0:18               unassigned      YES unset  down                  down   Serial2/0:19               unassigned      YES unset  down                  down   Serial2/0:20               unassigned      YES unset  down                  down   Serial2/0:21               unassigned      YES unset  down                  down   Serial2/0:22               unassigned      YES unset  down                  down   Serial2/0:23               unassigned      YES unset  down                  down   Serial2/0:24               unassigned      YES unset  down                  down   Serial2/0:25               unassigned      YES unset  down                  down   Serial2/0:26               unassigned      YES unset  down                  down   Serial2/0:27               unassigned      YES unset  down                  down   Serial2/0:28               unassigned      YES unset  down                  down   Serial2/0:29               unassigned      YES unset  down                  down   NVI0                       10.1.3.254      YES unset  up                    up     Tunnel0                    172.16.2.2      YES NVRAM  up                    up     В чем может быть проблема!? Интерфейсы 1-15,17-30 должны быть в апе? куда копать!?