The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

fxp (4)
  • >> fxp (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    fxp
    
     - Intel EtherExpress PRO/100 Ethernet device driver
    
     
    

    SYNOPSIS

    To compile this driver into the kernel, place the following lines in your kernel configuration file:
    device miibus device fxp

    Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

    if_fxp_load="YES"
    
     

    DESCRIPTION

    The driver provides support for Ethernet adapters based on the Intel i82557, i82558, i82559, i82550, and i82562 chips.

    The driver supports the following media types:

    autoselect
    Enable autoselection of the media type and options
    10baseT/UTP
    Set 10Mbps operation
    100baseTX
    Set 100Mbps (Fast Ethernet) operation

    The driver supports the following media options:

    full-duplex
    Set full duplex operation

    Note that 100baseTX media type is not available on the Pro/10. For further information on configuring this device, see ifconfig(8).

    The driver supports reception and transmission of extended frames for vlan(4). This capability of can be controlled by means of the vlanmtu parameter to ifconfig(8).

    The driver also supports a special link option:

    link0
    Some chip revisions have loadable microcode which can be used to reduce the interrupt load on the host cpu. Not all boards have microcode support. Setting the link0 flag with ifconfig(8) will download the microcode to the chip if it is available.

     

    HARDWARE

    Adapters supported by the driver include:

     

    DIAGNOSTICS

    "fxp%d: couldn't map memory"
    A fatal initialization error has occurred.
    "fxp%d: couldn't map interrupt"
    A fatal initialization error has occurred.
    "fxp%d: Failed to malloc memory"
    There are not enough mbuf's available for allocation.
    "fxp%d: device timeout"
    The device has stopped responding to the network, or there is a problem with the network connection (cable).
    "fxp%d: Microcode loaded, int_delay: %d usec bundle_max: %d"
    The chip has successfully downloaded the microcode, and changed the parameterized values to the given settings.

     

    SEE ALSO

    altq(4), arp(4), miibus(4), netintro(4), ng_ether4, polling(4), vlan(4), ifconfig(8)  

    HISTORY

    The device driver first appeared in Fx 2.1 .  

    AUTHORS

    An -nosplit The device driver was written by An David Greenman . It has then been updated to use the busdma API and made endian-clean by An Maxime Henrion . This manual page was written by An David E. O'Brien .


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    HARDWARE
    DIAGNOSTICS
    SEE ALSO
    HISTORY
    AUTHORS


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру