Интерактивная система просмотра системных руководств (man-ов)
setfdprm (1)
>> setfdprm (1) ( Linux man: Команды и прикладные программы пользовательского уровня )
setfdprm (8) ( Linux man: Команды системного администрирования )
Name
setfdprm - sets user-provided floppy disk parameters
Note
This manpage has been automatically generated from fdutils's texinfo
documentation. However, this process is only approximative, and some
items, such as crossreferences, footnotes and indices are lost in this
translation process. Indeed, these items have no appropriate
representation in the manpage format. Moreover, only the items specific
to each command have been translated, and the general information about
fdutils has been dropped in the manpage version. Thus I strongly advise
you to use the original texinfo doc.
*
To generate a printable copy from the texinfo doc, run the following
commands:
./configure; make dvi; dvips fdutils.dvi
*
To generate a html copy, run:
./configure; make html
A premade html can be found at:
Infinityhttp://www.tux.org/pub/knaff/fdutilsIntegral
*
To generate an info copy (browsable using emacs' info mode), run:
./configure; make info
The texinfo doc looks most pretty when printed or as html. Indeed, in
the info version certain examples are difficult to read due to the
quoting conventions used in info.
setfdprm is a utility that can be used to load disk parameters
into the auto-detecting floppy devices and "fixed parameter" floppy
devices, to clear old parameter sets and to disable or enable diagnostic
messages. These parameters are derived from a media-description,
see section Media description for more details.
Without any options, setfdprm loads the device (for example
Infinity/dev/fd0Integral or Infinity/dev/fd1Integral) with a new parameter set with the
name entry found in Infinity/etc/fdprmIntegral (usually named 360/360,
etc.). For autodetecting floppy devices, these parameters stay in
effect until the media is changed. For "fixed parameter" devices, they
stay in effect until they are changed again.
Setfdprm can also be used by the superuser to redefine the
default formats.
Options
-p device name
Permanently loads a new parameter set for the specified auto-configuring
floppy device for the configuration with name in
Infinity/etc/fdprmIntegral. Alternatively, the parameters can be given directly
from the command line.
-c device
Clears the parameter set of the specified auto-configuring floppy device.
-y device
Enables format detection messages for the specified auto-configuring floppy
device.
-n device
Disables format detection messages for the specified auto-configuring
floppy device.
