Проект OpenNet: MAN sigemptyset (3) Библиотечные вызовы (FreeBSD и Linux)

Интерактивная система просмотра системных руководств (man-ов)

sigemptyset (3)

sigemptyset (3) ( FreeBSD man: Библиотечные вызовы )

sigemptyset (3) ( Русские man: Библиотечные вызовы )

sigemptyset (3) ( Linux man: Библиотечные вызовы )

>> sigemptyset (3) ( POSIX man: Библиотечные вызовы )

NAME

sigemptyset - initialize and empty a signal set

SYNOPSIS

#include <signal.h>

int sigemptyset(sigset_t *set);

DESCRIPTION

The sigemptyset() function initializes the signal set pointed to by set, such that all signals defined in IEEE Std 1003.1-2001 are excluded.

RETURN VALUE

Upon successful completion, sigemptyset() shall return 0; otherwise, it shall return -1 and set errno to indicate the error.

ERRORS

No errors are defined.

The following sections are informative.

EXAMPLES

None.

APPLICATION USAGE

None.

RATIONALE

The implementation of the sigemptyset() (or sigfillset()) function could quite trivially clear (or set) all the bits in the signal set. Alternatively, it would be reasonable to initialize part of the structure, such as a version field, to permit binary-compatibility between releases where the size of the set varies. For such reasons, either sigemptyset() or sigfillset() must be called prior to any other use of the signal set, even if such use is read-only (for example, as an argument to sigpending()). This function is not intended for dynamic allocation.

The sigfillset() and sigemptyset() functions require that the resulting signal set include (or exclude) all the signals defined in this volume of IEEE Std 1003.1-2001. Although it is outside the scope of this volume of IEEE Std 1003.1-2001 to place this requirement on signals that are implemented as extensions, it is recommended that implementation-defined signals also be affected by these functions. However, there may be a good reason for a particular signal not to be affected. For example, blocking or ignoring an implementation-defined signal may have undesirable side effects, whereas the default action for that signal is harmless. In such a case, it would be preferable for such a signal to be excluded from the signal set returned by sigfillset().

In early proposals there was no distinction between invalid and unsupported signals (the names of optional signals that were not supported by an implementation were not defined by that implementation). The [EINVAL] error was thus specified as a required error for invalid signals. With that distinction, it is not necessary to require implementations of these functions to determine whether an optional signal is actually supported, as that could have a significant performance impact for little value. The error could have been required for invalid signals and optional for unsupported signals, but this seemed unnecessarily complex. Thus, the error is optional in both cases.

FUTURE DIRECTIONS

None.

COPYRIGHT

Portions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at http://www.opengroup.org/unix/online.html .