The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

tcic (4)
  • >> tcic (4) ( Linux man: Специальные файлы /dev/* )
  •  

    NAME

    tcic - Databook TCIC-2 PCMCIA controller driver
     
    

    SYNOPSIS

    insmod tcic.o [pc_debug=n] [tcic_base=n] [ignore=n] [do_scan=n] [irq_list=i,j,...] [cs_irq=n] [poll_interval=n] [poll_quick=n] [cycle_time=n]  

    DESCRIPTION

    This is the low-level driver for the Databook TCIC-2 PCMCIA host controller family. It is used by Card Services for programming the TCIC-2 chip, and for monitoring card status change events.  

    PARAMETERS

    pc_debug=n
    Selects the PCMCIA debugging level. This parameter is only available if the module is compiled with debugging enabled. A non-zero value enables debugging.
    tcic_base=n
    Sets the base I/O port address of the TCIC-2 chip. The default is 0x240.
    ignore=n
    Causes the driver to ignore a single socket. Sockets are numbered starting at 0. The socket will be left in whatever state it was already in, so it can be used for cards with point enablers that do not cooperate with Card Services.
    do_scan=n
    This flag specifies that all free interrupts should be tested to see if they can be triggered by the PCMCIA controller. The default is 1 (on).
    irq_list=i,j,...
    Specifies the set of interrupts that may be allocated by this driver, if they are otherwise available. The default list is 3, 4, 5, 6, 7, 10, 11, and 14.
    cs_irq=n
    Sets the interrupt line to use for monitoring card status changes. The default is 0, which means pick any legal interrupt not already in use. Legal values are 14, 10, 7, 6, 5, 4, and 3.
    poll_interval=n
    Sets the card status polling delay, in 1/100 second increments. If this parameter is set, card status interrupts will be disabled.
    poll_quick=n
    When a card status change interrupt is received, the TCIC-2 chip is briefly polled for additional status changes. This parameter sets the polling delay, in 1/100 second increments. The default is 5, meaning 0.05 seconds.
    cycle_time=n
    Sets the length of a CCLK external clock cycle, in nanoseconds. The default is 70 ns, corresponding to a standard ISA 14.31818 MHz clock.
     

    AUTHOR

    David Hinds - dahinds@users.sourceforge.net  

    SEE ALSO

    cardmgr(8), pcmcia(5).


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    PARAMETERS
    AUTHOR
    SEE ALSO


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру