# pci-config -u
Usage: pci-config [-aDfSvVW] [-# <device_index>] This program shows the contents of PCI configuration space.
It reads the hardware registers, and thus must be run as 'root'.
Running this program with no options shows the installed PCI devices.
Each line is prefixed by its index which may be used with -#<index>
e.g. "pci-config -#3" to specify the device to operate on.
Commonly use options are
-# <device-index> Operate only on DEVICE-INDEX e.g -#3
The operations on the selected device are
-a --show-addresses Show PCI address registers.
-S --sleep Put device to sleep (ACPI D3 state)
-W --wake Wake a sleeping device (ACPI D0 state)
Less commonly used options are
-B <bus> --bus <bus> Show only devices on BUS.
-A <addr> --set-addresses Set PCI address register 1 to the ADDR.
-D --debug Show details of operations
-f --force Override checks and perform the operation
-u --usage Show this long usage message
-v --verbose Verbose mode
-V --version Display this program's version information
# pcitweak
usage: pcitweak -l
pcitweak -r ID [-b | -h] offset
pcitweak -w ID [-b | -h] offset value
-l -- list
-r -- read
-w -- write
-b -- read/write a single byte
-h -- read/write a single halfword (16 bit)
ID -- PCI ID string in form bus:dev:func (all in hex)
Вариант для распечатки
OpenNET: Виртуальная конференция (Public)
(ok) on 12-Авг-07, 21:23 
