Обновите исходники и установите драйвер сетевухи посвежеее.
Building and Installation
=========================
NOTE: The driver can be installed as a dynamic loadable kernel module or
compiled into the kernel. You must have kernel sources installed in
order to compile the driver module.
In the instructions below, x.x.x is the driver version as indicated in the
name of the driver tar file.
1. Move the base driver tar file to the directory of your choice. For
example, use /home/username/em or /usr/local/src/em.
2. Untar/unzip the archive:
tar xzvf em-x.x.x.tar.gz
This will create an em-x.x.x directory.
3. To create a loadable module, perform the following steps.
NOTE: To compile the driver into the kernel, go directly to step 4.
a. To compile the module
cd em-x.x.x
make
b. To install the compiled module to the system directory:
make install
c. If you want the driver to load automatically when the system is booted:
1. Edit /boot/loader.conf, and add the following line:
if_em_load="YES"
4. To compile the driver into the kernel, enter:
cd em-x.x.x/src
cp *.[ch] /usr/src/sys/dev/em
Edit the kernel configuration file (i.e., GENERIC or MYKERNEL) in
/usr/src/sys/i386/conf, and ensure the following line is present:
device em
Compile and install the kernel. The system must be rebooted for the
kernel updates to take effect. For additional information on compiling
the kernel, consult the FreeBSD operating system documentation.
5. To assign an IP address to the interface, enter the following:
ifconfig em<interface_num> <IP_address>
6. Verify that the interface works. Enter the following, where <IP_address>
is the IP address for another machine on the same subnet as the interface
that is being tested:
ping <IP_address>
7. To configure the IP address to remain after reboot, edit /etc/rc.conf,
and create the appropriate ifconfig_em<interface_num>entry:
ifconfig_em<interface_num>="<ifconfig_settings>"
Example usage:
ifconfig_em0="inet 192.168.10.1 netmask 255.255.255.0"
NOTE: For assistance, see the ifconfig man page.
А еще есть polling:
Polling
------- To enable polling in the driver, add the following options to the kernel
configuration, and then recompile the kernel:
options DEVICE_POLLING
options HZ=1000
At runtime use:
ifconfig emX polling (to turn polling on)
and:
ifconfig emX -polling (to turn it off)
Вариант для распечатки
OpenNET: Виртуальная конференция (Public)
(??) on 25-Ноя-07, 17:05 
