залил c2950_i6k2l2q4_mz.121_22.EA5a.bin
в лог перестала сыпать
однако напрягают ошибки
FastEthernet0/4 is up, line protocol is up (connected)
Hardware is Fast Ethernet, address is 0007.8433.ae04 (bia 0007.8433.ae04)
MTU 1500 bytes, BW 10000 Kbit, DLY 100 usec,
reliability 252/255, txload 2/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 10Mb/s, media type is 100BaseTX
input flow-control is unsupported output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:07:59
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 47000 bits/sec, 46 packets/sec
5 minute output rate 90000 bits/sec, 47 packets/sec
25832 packets input, 3352915 bytes, 0 no buffer
Received 44 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
25524 packets output, 5006100 bytes, 0 underruns
341 output errors, 246 collisions, 0 interface resets
0 babbles, 341 late collision, 409 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
у кого какие мысли?
дуплекс и скорость стоят авто, но играние этими параметрами к особым переменам не приводит
|
Вариант для распечатки
Маршрутизаторы CISCO и др. оборудование. (Cisco Catalyst коммутаторы)
(ok) on 01-Фев-06, 16:59 
