program will resize ext2 or ext3 file systems. It can be used to enlarge or
shrink an unmounted file system located on
If the filesystem is mounted, it can be used to expand the size of the
mounted filesystem, assuming the kernel supports on-line resizing. (As
of this writing, the Linux 2.6 kernel supports on-line resize for
filesystems mounted using ext3 only.).
parameter specifies the requested new size of the filesystem.
If no units are specified, the units of the
parameter shall be the filesystem blocksize of the filesystem.
parameter may be suffixed by one of the following the units
designators: 's', 'K', 'M', or 'G',
for 512 byte sectors, kilobytes, megabytes, or gigabytes, respectively.
of the filesystem may never be larger than the size of the partition.
parameter is not specified, it will default to the size of the partition.
program does not manipulate the size of partitions. If you wish to enlarge
a filesystem, you must first make sure you can expand the size of the
underlying partition first. This can be done using
by deleting the partition and recreating it with a larger size or using
if you're using the logical volume manager
recreating the partition, make sure you create it with the same starting
disk cylinder as before! Otherwise, the resize operation will
certainly not work, and you may lose your entire filesystem.
run resize2fs to resize the ext2 filesystem
to use all of the space in the newly enlarged partition.
If you wish to shrink an ext2 partition, first use
to shrink the size of filesystem. Then you may use
to shrink the size of the partition. When shrinking the size of
the partition, make sure you do not make it smaller than the new size
of the ext2 filesystem!
Turns on various resize2fs debugging features, if they have been compiled
into the binary.
should be computed by adding the numbers of the desired features
from the following list:
1 - Print out all disk I/O
2 - Debug block relocations
8 - Debug inode relocations
16 - Debug moving the inode table
program will heuristically determine the RAID stride that was specified
when the filesystem was created. This option allows the user to
explicitly specify a RAID stride setting to be used by resize2fs instead.
Prints out a percentage completion bars for each
operation, so that the user can keep track of what
the program is doing.
Forces resize2fs to proceed with the filesystem resize operation, overriding
some safety checks which resize2fs normally enforces.
Flush the filesystem device's buffer caches before beginning. Only
really useful for doing